G E T T I N G STA RT E D :
Carefully unpack your shades and check to make sure you have the
following parts. We recommend reading through these instructions before
starting the installation.
PA RTS I N C LU D E D :
• Screws
•
2
mounting brackets
• Wand (if selected)
• Valance
• Cord cleat
• Auxiliary support bracket(s)
(optional)
Please note that your brackets must be securely attached to the mounting
surface. If your screws cannot attach to wood studs, please use a different
fastener, which can be found at any hardware store.
TO O L S YO U W I L L N E E D :
• Drill with a
V
" bit
• Phillips bit
• Flathead screwdriver
• Metal tape measure
1 . I N STA L L AT I O N I N ST R U C T I O N S :
Unwrap the blind. Do not untie cord at this time. Hold the blind against
the window to determine the proper placement. It will either fit inside
the window casing (inside mount) or outside the window casing (outside
mount). This will determine where and how your installation brackets
should be attached.
Inside Mount:
Make certain the headrail is level and clear of obstructions.
Make pencil marks
V
" below the headrail on each end. The bottom of the
installation brackets will be placed on these marks.
Outside Mount:
Hold the blind level and center against the window casing
or wall. Mark the casing or wall with a pencil just below the headrail on
each end. Also mark the window casing or wall
V
" beyond the ends of the
headrail. The installation brackets will be placed on these marks.
AUXILIARY SUPPORT
BRACKETS IF SUPPLIED
MOUNTING
BRACKET
HEADRAIL
WAND
VALANCE
CORD CLEAT
STANDARD
CONTROL
INSIDE MOUNT
OUTSIDE MOUNT
Mark
V
"
below
both ends of
the headrail
Remember to keep headrail level -
even if your window isn’t.
WINDOW
CASING
MARK
Mark
V
"
below
both ends of
the headrail
Remember to keep headrail level -
even if your window isn’t.
WINDOW
CASING
MARK
INSIDE MOUNT
OUTSIDE MOUNT
CUSTOMER SERVICE 888.669.2809
082112
WOOD BLINDS INSTALLATION INSTRUCTIONS
