21
4.3 Fitting eye terminal to swaged stud (Stud/Eye)
1. Remove the toggle from the eye terminal.
2. Screw the eye terminal part onto the stud terminal until the holes in stud and eye align.
3. Fit the spirol spring pin using a hammer to permanently lock the terminal.
4. Check that the length of the luff section corresponds to the NFL measurement, table 2 page 11.
If it does, the luff section is now ready to be rigged.
4.4 Fitting lower eye terminal to rod stay
1. Screw out the socket on the lower terminal part or rigging screw and remove the wedge and the
former. These three parts are not to be used in rod application. Remove the toggle from the terminal
part or rigging screw.
2. Add 2-3 drops of locking adhesive on the thread and screw the terminal together. Check that
the rod head sits correctly in the seat and that the seat sits correctly in the socket.
3. Tighten firmly for permanent locking.
4. Check that the length of the luff section corresponds to the NFL measurement,
table 2 page 11.
If it does, the luff section is now ready to be rigged.
