9
‐
10
Segway®
Personal
Transporter
i2,
x2,
x2
Turf
Parts
Replacement
6.
Lift
UIC
straight
up
until
clear
of
locator
pin
(refer
to
1
in
).
Figure
9
‐
10:
Lift
or
Lower
UIC
Over
Locator
Pin
7.
Angle
UIC
upward
from
rear
(refer
to
2
in
to
expose
UIC
connectors
to
A
and
B
CU
harnesses.
While
pressing
connector
locking
tabs,
gently
remove
connectors
to
disconnect.
Do
not
strain
harnesses.
See
.
Figure
9
‐
11:
Disconnect
or
Connect
A
and
B
Harnesses
8.
Lift
off
UIC
and
place
in
ESD
bag
or
on
clean
ESD
work
surface.
To install UIC:
1.
Make
sure
Segway
PT
is
powered
off
and
unplugged.
2.
Inspect harnesses for damage to insulation or
kinks. Ensure connector locking mechanism is
intact.
If harness wires are pinched or exhibit insulation
damage or the connector is damaged so as to
prevent positive locking upon installation, the
harness must be replaced.
3.
Orient
UIC
in
console
housing.
Make
sure
CU
harnesses
are
properly
positioned
in
plastic
guide
clips
to
prevent
crushing
of
harnesses.
4.
To
avoid
crushing
steering
sensor
harnesses,
make
sure
harnesses
are
properly
positioned
in
channel
around
UIC
mounting
bosses.
See
5.
Be
sure
retention
putty
is
installed
and
keeps
harness
seated
correctly
around
bosses.
6.
Connect
(2)
CU
harness
connectors
to
front
of
UIC.
7.
Orient
hole
in
UIC
over
locator
pin
(refer
to
1
in
)
and
lower
UIC
into
console
housing,
taking
care
to
fold
harnesses
into
void
without
pinching.
Figure
9
‐
12:
Position
Harnesses
in
Channel
locator
pin
A
harness
B
harness
UIC
console
locator
pin
REAR
VIEW
