Segway Personal Transporter i2, Parts Replacement Manual

Page: 38 / 126

4 ‐ 4 Segway® Personal Transporter i2, x2, x2 Turf Parts Replacement
Tire/Wheel Assembly Removal and Installation, x2 only
To remove tire/wheel assembly:
1. Make sure Segway PT is powered off and
unplugged.
2. Support unit or turn unit on its side.
3. If removing tire/wheel assembly and hub
adapter, proceed to page 4 ‐ 6 .
4. Use 8mm hex wrench to remove (4)
fasteners. See Figure 4 ‐ 2 .
Figure 4 ‐ 2: Remove or Install Tire/Wheel Assembly, x2
5. Lift off wheel trim.
6. Loosen tire/wheel assembly by tapping side
of wheel with plastic or rubber mallet.
7. Lift off tire/wheel assembly.
To install tire/wheel assembly:
1. Make sure Segway PT is powered off and
unplugged.
2. Inspect wheel mounting surfaces; use
alcohol wipes to clean off all debris.
3. Place wheel over hub adapter with valve
stem facing outward; align mounting holes.
4. Place wheel trim on wheel; align mounting
holes. See Figure 4 ‐ 2 .
5. Thread (4) 8mm fasteners (20991 ‐ 00001)
through trim and wheel and into hub
adapter.
6. While holding tire to keep from rotating, use
8mm torque wrench to tighten to 30 N ‐ m.
Tighten only to the
prescribed torque.
7. Perform post ‐ service tests ( page A ‐ 1 ).
Tire and Wheel
18357-00002
Wheel Trim
20965-00001
20991-00001