Segway NINEBOT ONE S1, Service Manual

Page: 41 / 74

Service Manual
41
Frame
Thermal
Paste
Thermal
Paste
Figure 49: Apply thermal paste
FRONT REAR
Plug In
Figure 50: Plug in the temperature sensor
Figure 51: Rubber gasket orientation
Figure 52: Control board orientation
FRONT
REAR
Lip
Assembly
1. Apply thermal paste on the the two aluminum
pads, as shown in
Figure 49 .
2. Place the control board on top of the heat sink
and install nine screws:
a. Five screws on top ( Figure 46 ).
b. Four screwson bottom ( Figure 47 ).
3. Plug in the temperature sensor ( Figure 50 ).
4. Orient the control board gasket as shown in
Figure 51 , with the lip up and toward the rear.
Install the control board gasket.
5. Continue to install in the reverse order of
removal.
NOTE
If you installed a new control board, you will need
to reset the serial number (
page 64
).