Segway NINEBOT ONE S1, Service Manual

Page: 14 / 74

Batteries
14
One S1
Battery Cover
Tools Required
• Phillips screwdriver
Removal
Make sure the One S1 is powered off and the
charger is not connected.
1. Remove the silicone plug ( Figure 1 ).
2. Use a Phillips screwdriver to remove the two
screws (
Figure 2 ).
3. Use your hand to grab the battery cover between
the now-empty screw holes. Pull the battery cover
off the One S1.
NOTE
It may take a great deal of force to remove the
battery cover.
Installation
1. Verify that the gasket is securely installed in the
groove (
Figure 3 ).
2. Position the battery cover on the One S1. Line
up the tabs on the cover with the slots on the
housing (
Figure 4 ).
3. Press the battery cover onto the housing. Press
until it snaps in place.
4. Use a Phillips screwdriver to install the two screws
removed earlier (
Figure 2 ).
5. Reinstall the silicone plug ( Figure 1 ).
Figure 1: Remove the silicone plug
Figure 2: Remove the two Phillips-head screws
Figure 3: Verify gasket is installed
Figure 4: Line up cover tabs with slots in the housing
Gasket