Segway NINEBOT ONE S1, Service Manual

Page: 34 / 74

Body
34
One S1
Install Left Side Panel
1. Verify that that wire guide (MK2b) is installed.
See
Figure 35 .
2. Guide the battery harnesses through the hole in
the side panel (
Figure 36 ).
3. Connect both LED strips.
4. Gently lay the side panel against the frame,
making sure not to pinch any wires between the
components.
5. Using a 3 mm hex wrench, install four fasteners
securing the side panel to the wheel (
Figure 37 ).
6.
Using a Phillips screwdriver, install five fasteners
securing the side panel to the frame ( Figure 37 ).
7. Flip the unit over and install the last Phillips-head
fastener on that side (
Figure 38 ).
8. Install a new Warranty Void sticker over the
bottom-right fastener on each side.
Figure 35: Mount the left side panel
Install screw
on right side
Wire guide “MK2b”
Figure 36: Connect the left side panel to the frame
Plug in
Plug in
Guide through hole
Figure 37: Connect the left side panel to the frame
Figure 38: Install the last fastener on the right side panel
Install screws
and hex bolts