Segway NINEBOT ONE S1, Service Manual

Page: 39 / 74

Service Manual
39
Frame
Installation
1. Plug in the charge port, buzzer, handle sensor,
and ON/OFF button (
Figure 41 and Figure 42 ).
2. Install the U-grommets as shown in Figure 40 .
3. Install the control board assembly:
a. Insert the motor wires through the holes in
the sides of the upper frame.
b. Press the U-grommets into the grooves in the
upper frame (
Figure 43 ).
c. Use a 3 mm hex wrench to install the four
fasteners (
Figure 39 ).
4. Continue to install in the reverse order of
removal.
Figure 42: Plug in all wire harnesses
LED Strips, Front
LED Strips, Rear
Battery Power Battery Communication
Battery Communication Battery Power
Motor Communication
Motor Power
LEFT SIDE
RIGHT SIDE
Figure 44: Control board connectors
Figure 43: Install U-grommets