23
CHAPTER 2
Operating modes
In order to use Flasher in “remote-controlled mode”, it has to be configured first, as de-
scribed in
Setting up Flasher for remote-controlled mode
on page 30.
2.3.2 Handshake mode
The handshake mode provides a simple way to start the flashing of the connected targets.
The pins 1, 4, 5 and 7 of the RS232 connector can be used to e.g. connect a start button
and two indicator LEDs for programming control. The following picture show the Flasher
ATE internal logic and the signal states during the programming sequence.
Note
The Flasher ATE will not provide any detail error codes during this mode. We recom-
mend to use the remote controlled mode for mass production.
In order to use Flasher in “handshake mode”, it has to be configured first, as described in
Setting up Flasher for handshake mode
on page 32.
Flasher ATE User Guide (UM08035)
© 2017-2018 SEGGER Microcontroller GmbH
