Using at least two people and step ladders,
guide the marquee assembly onto the weldment
marquee support
3
, by inserting the two
rectangular tubes
7
through the rear of the
marquee (Figure 18). When the assembly is
fully seated, the mounting holes inside the
marquee should align with the holes on the
tubes
7
. (Figures 19 &20). Install
1
/
4
-20X
3
/
4
bolts and flat washers and lock washers to
secure each side of the marquee to its
respective tube
7
(Figure 20) Eight bolts total,
four in each tube.
When the marquee is secured, feed the
fluorescent power cord up through the hole on
the top of the tube and connect to the 3 pin
housing on the fluorescent fixture s harness
(Figure 20). Next, connect the housing located
on the lower end of the tube
7
, to the 3 pin plug
in the lower cabinet (Figure 21).
Remove the plastic film from the marquee plate
and re-install the plate in the assembly using the
screws and decorative washers you removed
earlier. (Figure 22)
Figure 18
Figure 19
Figure 20
Figure 21
Figure 22
Fluorescent
fixture's harness
Fluorescent
fixture's harness
13
