Sega Let's Go Jungle, Owner'S Manual

Page: 40 / 167

ASSEMBLY AND INSTALLATION
35
6
● When connecting the DVD wire connector, check the orientation carefully and
connect securely. The connector must be connected in the proper direction. If
it is connected in the wrong direction or indiscriminately at an incline so that a
load is applied, the connector or its terminal pins could break, causing a short
circuit or fire.
● Be careful not to damage the DVD wire by getting it caught between objects,
etc. Doing so may cause a short circuit or fire.
● Connect the DVD DRIVE to the LINDBERGH before connecting the power. Ad-
here strictly to the proper sequence in performing work. Failing to do so may
cause electrical shock or short circuit.
1
Remove the outlet plate on the bottom right
of the front door PCB. Remove the two truss
screws.
You will need the supplied DVD software kit, board number sticker, and the separately sold DVD DRIVE and DVD
wire. To prepare for software installation, you will need to connect the LINDBERGH and DVD DRIVE inside the
cabinet using the DVD wire.
The LINDBERGH is the orange colored plate metal case found inside the front door PCB on the left side when fac -
ing the projector screen.
2
Remove the anti-release screw used to prevent
removal of the front door PCB.
FIG. 6-11a
FIG. 6-11b
11 CONNECTING THE DVD DRIVE (PREPARATION FOR INSTALLATION)
PLEASE NOTE THAT THIS PRODUCT IS DESPATCHED WITH SOFTWARE PRE-INSTALLED
TRUSS SCREW (2), black
M4x16
OUTLET PLATE
TRUSS SCREW (1), black
M4x40