66
TROUBLESHOOTING
16
PROBLEMS
CAUSE
COUNTERMEASURES
Colors on the monitor screen are
strange.
Faulty connection for the visual
signal connector.
Check the visual signal connector connec-
tion and make sure it is secured properly.
Screen adjustment is not appro-
priate.
Make adjustment appropriately.
(See chapter 13.)
Does not accept input from any
switch or volume.
Faulty connector connections.
Check the connection for the I/O board and
cabinet connector.
Check the power for the I/O board.
The steering (servomotor) does
not respond correctly or accu-
rately.
An error occurred during the
power-on check.
Switch the power off and on again, and con-
fi
rm that the power-on check is performed
correctly.
Steering volume is not con
fi
gured
correctly.
Con
fi
gure the volume in test mode.
Volume not installed correctly/
Adjust gears not engaged cor-
rectly.
Adjust the installation, and con
fi
rm in test
mode (See chapter 9).
Volume is broken.
Replace volume (See chapter 9).
A wire has been severed/discon-
nected.
Check that the wires running close to any
moving parts are connected properly. When
replacing wires, route them so that they do
not come into contact with any moving parts.
The steering (servomotor) does
not respond at all.
An error occurred during the
power-on check.
Switch the power off and on again, and con-
fi
rm that the power-on check is performed
correctly.
Faulty connection.
Check all the connectors leading from the
game board to the servo driver and from the
servo driver to the servomotor.
The thermal element in the servo
driver has activated.
The thermal element kicks in when the in-
ternal temperature reaches approximately 70
. When the temperature cools suf
fi
ciently,
the unit will automatically start up again.
The servo driver fuse has blown
due to a momentary overloading.
Contact the dealer where the unit was pur-
chased.
The steering (servomotor) is
weak.
The recoil mechanism has come
out of adjustment with use.
Recon
fi
gure settings in test mode.
Accelerator and brake inputs do
not work correctly.
Volume is not con
fi
gured cor-
rectly.
Con
fi
gure the volume in test mode.
Volume not installed correctly/
Adjust gears not engaged cor-
rectly.
Adjust the installation, and con
fi
rm in test
mode (See chapter 11).
Faulty connection.
Check all the connections inside the ac-
celerator and brake units, and check the con-
nections leading from the game cabinet to
the accelerator and brake.
Volume is broken.
Replace volume (See chapter 11).
Pressing the start, view change, or
directional buttons has no effect.
The buttons do not
fl
ash.
Faulty connection.
Check all the connections between the I/O
board, the cabinet, and the switch unit.
Rubber section is torn.
Check to see if the rubber section inside the
switch unit is torn.
Switch unit is broken.
Contact the dealer where the unit was pur-
chased.
Cannot perform DVD setup. The
display stays at the LINDBERGH
logo and does not advance to the
advertising screen (Error 6).
DVD drive is broken.
Connecting cable is broken.
Check the manual that came with the DVD
drive kit.
DVD disc is broken.
Contact the dealer where the unit was pur-
chased.
The display stays at the LIND-
BERGH logo and does not
advance to the advertising screen
(other error).
LINDBERGH con
fi
gured incor-
rectly or malfunctioning.
Referchapter 16-3 “ERROR CODE FOR
LINDBERGH.”
Summary of Contents for Initial D4
Page 1: ......
