35
CONTROL PANEL
9
CONTROL PANEL
9
●
In order to prevent an electric shock and short circuit, be sure to turn power off before performing work by touch-
ing the interior parts of the product.
●
Be careful not to damage the wires. Damaged wires may cause electric shock or short circuit.
●
Do not touch undesignated places. Touching places not designated can cause electric shock or short circuit.
●
This work should be performed by the Location's Maintenance Man or Serviceman. Performing work by non-tech-
nical personnel can cause electric shock hazard.
●
Do not perform work other than those speci
fi
ed in this Manual in order to prevent accidents during performing
work and operation after performing work. If performing work other than those stated in this manual is required for
repair, contact the of
fi
ces herein stated in this manual.
●
Be very careful when soldering. Handling a soldering iron carelessly may result in a
fi
re or a burn.
●
Be extremely careful when heating the heat-shrinkable tube. Failure to do so may result in a
fi
re or burns.
●
The motor parts will be very hot after shutting down the game. After shutdown, wait a few moments for the motor
parts to cool before you begin working on the unit.
●
Exercise extreme caution when handling the internal parts of the Control Panel. Watch out for damage, warping
and loss. The loss of just one piece may result in damage to or lead to faulty operation of the entire unit.
●
Be careful that your
fi
ngers do not get caught when opening and closing the control panel, adjusting the VR
bracket, or performing other maintenance tasks.
●
When securing the plastic-made parts, do not excessively fasten screws and nuts. Failure to observe this may
damage the parts and cause injury due to fragments resulting from damage.
●
Do not touch the steering wheel when switching on the unit. The steering wheel undergoes automatic initialization
after the unit is switched on.
Be sure to perform volume's move value setting in the INPUT ASSIGNMENTS in the Game Test
Mode after replacing or adjusting the Volume.
1
Switch off the unit.
2
Using a tamperproof wrench, remove the four screws that
secure the control panel upper cover, and then detach the
cover.
If the steering wheel is not functioning correctly, or if adjusting the volume has no effect in test mode, the volume may
not be engaged correctly or it may be defective. Follow the steps below to adjust the gear engagement or replace the
volume. In this unit, as long as the volume’s maximum range of motion is not exceeded when the steering wheel is
turned to the extreme left or right, the volume should not fail. Make sure that the steering wheel is centered (that is to
say, positioned to drive directly forward), and install the volume so that its axis is aligned in the direction indicated by
the diagram, with the gears engaged appropriately (see 9-2 FIG 01). To adjust or replace the volume, open the control
panel according to the steps below. For this task, you will require a tamperproof wrench (for M4 screws).
9-1 OPENING THE CONTROL PANEL
9-1 FIG. 01
TAMPERPROOF SCREW (4), black
8-32 x 1/2" Torx TT-25
CONTROL PANEL UPPER COVER
Summary of Contents for Initial D4
Page 1: ......
