STARTING YOUR COOLER
AUTOMATIC MODE
MANUAL MODE
The
button turns the air cooler on and off.
There are two modes of operation to choose from,
Automatic mode or Manual mode. When the air cooler is
turned on, it will start in the mode of operation it was in
when last turned off. If your air cooler has been off for
more than (about) 10 minutes, when you start it,
“
Preparing to Start
”
may flash on the display as shown.
This shows that the water pump will operate to saturate
the cooling pads for a few minutes, before the fan is
turned on. This ensures that when the fan starts, only
cool air enters the building.
The
button is used to select Automatic mode or
Manual mode. When
“
Auto
”
is displayed the cooler is
under Automatic control and will operate according to the
temperature sensed at the wall control.
When the air cooler is turned on, it will read the
temperature and set the cooler operation accordingly. If
the temperature increases at the wall control, then the fan
speed will increase. As the temperature decreases the fan
speed will decrease until the cooler turns off.
Press
or
to overide the automatic cooling
level setting and adjust your room temperature.
To switch to Manual mode, press
until
“
Man
”
appears in the display.
In Manual mode the cooling level can be manually
adjusted.
In Manual mode, press
to choose between
circulating cool air or uncooled air. When
“
Cool
”
is
displayed, fresh cool air will circulate into the building.
When
“
Vent
”
is displayed as shown, fresh uncooled air
will circulate through the building.
Press
to increase the fan speed and circulate
more air. Press
to decrease the fan speed and
circulate less air. Press once to change the speed by
one increment. Hold the button down to change the
speed more quickly.
You can set the air cooler so that it will turn on after a
set number of hours.
1. To set the delayed start time, press
with the cooler turned
.
“
Starting in
”
will be
displayed as shown with the last mode of operation
(Manual or Automatic).
2. If you want the air cooler to turn on in Automatic
mode with the previous settings, then press
until
“
Auto
”
is displayed. Alternatively, if you want the air
cooler to turn on in Manual mode, press
until
“
Man
”
is displayed, then press
and then
or
to set the required fan speed.
3. To set the time until the start, press
.
4. Then press
or
to adjust the time. The
cooler can start up to 24 hours in advance.
5. Press
again to initiate the timed automatic
start. The timed start will not repeat.
OFF
TIMED AUTOMATIC START
.
ILL1122-A
ILL1124-A
AUTOMATIC MODE DISPLAY
ILL1122-A
MANUAL COOL DISPLAY
MANUAL VENT DISPLAY
ILL1123-A
ILL1117-A
5
SEELEY INTERNATIONAL –
INSTALLATION & OPERATION MANUAL
8
Using the
Wall Control
SENSOR
TOUCH
SENSOR
T
OUCH
W
allControl
