Q7-B03
Q7-B03 User Manual - Rev. First Edition: 1.0 - Last Edition: 1.1 - Author: S.B. - Reviewed by G.G. Copyright © 2017 SECO S.r.l.
55
4.3.11.1
LVDS Advanced options submenu
Menu Item
Options
Description
Spreading Depth
No Spreading / 0.5% /
1.0% / 1.5% / 2.0% /
2.5%
Sets percentage of bandwidth of LVDS clock frequency for spreading spectrum
Output Swing
150 mV / 200 mV / 250
mV / 300 mV / 350 mV /
400 mV / 450 mV
Sets the LVDS differential output swing
T3 Timing
0 ÷ 255
Minimum T3 timing of panel power sequence to enforce (expressed in units of 50ms). Default is 10
(500ms)
T4 Timing
0 ÷ 255
Minimum T4 timing of panel power sequence to enforce (expressed in units of 50ms). Default is 2 (100ms)
T12 Timing
0 ÷ 255
Minimum T12 timing of panel power sequence to enforce (expressed in units of 50ms). Default is 20 (1s)
T2 Delay
Enabled / Disabled
When Enabled, T2 is delayed by 20ms ± 50%
T5 Delay
Enabled / Disabled
When Enabled, T5 is delayed by 20ms ± 50%
P/N Pairs Swapping
Enabled / Disabled
Enable or disable LVDS Differential pairs swapping (Positive
Negative)
Pairs Order Swapping
Enabled / Disabled
Enable or disable channel differential pairs order swapping (A
D, B
CLK, C
C)
LVDS BUS Swapping
Enabled / Disabled
Enable or disable Bus swapping (Odd
Even)
4.3.12
SuperI/O configuration submenu
Menu Item
Options
Description
Name of the SuperI/O found
This menu item will show the name of all the Super I/Os that are found on the carrier board. By selecting the
adequate SuperI/O, it will be possible to set the serial ports and possibly other parameters as shown in the
following menu items. If no Super I/O is available on the Carrier Board, this menu will not be available.
Serial Port 1 / Serial Port 2 /
Serial Port 3 / Serial Port 4
Enabled / Disabled
Enable or Disable single serial port #1, #2, #3 or #4 (the number of serial ports depends on the Super I/O).
Address
0x3F8 / 0x2F8 / 0x3E8 / 0x2E8
/ 0x3E0 / 0x2E0 / 0x338 /
0x238 / 0x220 / 0x228
Select the Base address for each Serial Port, if enabled.
IRQ
3 / 4 / 5 / 6 / 7 / 10 / 11 / 14 /
15
Select the IRQ line to assign to each Serial Port, if enabled.
