9. Advanced Application - Various Working Modes Application
Access host can work in 8 modes as below.
1. Wiegand reader
2. Standalone for single door
1
*
Master
code #
4
0 #
Optional Setting
OFF
- The device will be in silence except enter
the programming mode
ON
-The device will give the voice when press the
keys (Factory default setting )
1 #
To set keypad tone
ON or OFF
No door bell function
Built-in
door bell - ON(Factory default setting)
External
door bell - ON
Built-in
&
external
door bell - ON
0 #
1 #
2 #
3 #
2
To set door bell function
Disable keypad backlight
Enable keypad backlight(Factory default setting)
Automatic mode
Normally it is off (sleeping mode) but wake up
with human approach
To set keypad backlight
0 #
1 #
2 #
3
Disable
Enable (Factory default setting)
To set logo LED light
(Stand-by status)
0 #
1 #
4
Administrator open the door
*
Master
code #
9
1
2
Administrator open door 1
Administrator open door 2
19
20
Red Black Green White
9.1 Wiegand Reader Mode
In this mode, the access host works as
reader, it can be done below settings.
> Change Master Code
Set Facility Code
Set the card transmission format
Set the keypad transmission format
Set optional setting
Anti-Tamper alarm
>
>
>
>
>
When LED level is low, Logo light will turn into Green, after 30 seconds or LED level rising, Logo light will back to normal.
When BZ level is low, the Buzzer will beep, after 30 seconds or BZ level rising, the Buzzer will back to normal.
When the access host worked as reader, both card number and keypad transmits in Wiegand format, the output data
are shown by the Low Level of D0 & D1 cable:
D0: Low Level means 0, green cable
D1: Low Level means 1, white cable
The Pulse Width of Low Level is 100uS, Bit period is 1.6mS
Red Black Green White
Common Access Controller
+
1
2
V
G
N
D
D
0
D
1
LE
D
B
Z
Red Black Green White Brown Yellow
i Box
-
1
2
V
G
N
D
D
0
D
1
(Automatic Mode)
Access Host
Access Host
(Wiegand Reader)
Access Host
(Other Modes)
Disable anti tamper alarm (Factory default setting)
Enable
anti tamper alarm
To set anti tamper alarm
0 #
1 #
5
3. Automatic mode (Factory default setting)
4. Standalone for two doors
5. With external reader for two doors
6. Two units interlocked for two doors
7. Anti-passback for single door
8. Anti-passback for two doors