*
1
Master
code #
1
User ID number
# PIN #
1. The user ID number is any number among
1- 2000.
2. The PIN is any 4-6 digits, digit must be
1 with the exception of 1234 which is reserved
3. Users can be added continuously without
exiting programming mode
st
1
To add
PIN
users
Add the card as for a card user
Press * exit from the programming mode, then allocate the card a
PIN as follows:
*
Read card 1234# PIN# Repeat PIN #
To add
Card
and
PIN
users
2
Card number #
Read Card
User ID number #
Note:
> Users can be deleted continuously without
exiting programming mode
> To delete
Card and PIN
users just delete the
card
To delete
Card
users
by card number
To delete
Card
users by cards
To delete
Card or PIN
users
3
0 #
Entry is by Card ONLY
1 #
2 #
Entry is by Card and PIN together
Entry is by either Card or PIN
(Factory default setting)
To set valid
Card
users
To set valid
Card and PIN
users
To set valid
Card or PIN
users
0~99 #
0 = 50mS, factory default setting: 5
To set door relay time
4
Every time a valid card/tag read or PIN input,
the relay will operate, for the pre-set relay
pulse time. (Factory default setting)
0 #
Relay Setting- Pulse mode
5
*
Master
code #
1
Every time a valid card/tag read or PIN input,
the relay changes state, which will not turn back
until read card/tag or input PIN again
Relay Setting-Toggle mode
1~10 #
Note: The door will open only when read the valid
card quantity up to the quantity set. It is only for
Card ONLY Mode (Factory default setting: 1 )
To set open door by multi
cards
6
User ID number #
Card number #
Card Quantity #
The card number must be consecutive
Card quantity is between 1-2000
To add a
series cards
users-
Block Enrollment
7
User Setting for Zone 2
*
Master
code #
2
The method is same as Zone 1, the only difference is the digit of PIN for Zone 2 must be 2
st
1
Advanced Application (System setting)
0
*
Master
code #
3
0~15#
Factory default setting: 0
To set facility code
Wiegand reader
Standalone for single door
Standalone for two doors
With external reader for two doors
Two units interlocked for two doors
Anti-passback for single door
Anti-passback for two doors
Automatic mode Factory default setting)
(
To set working mode
0#
1#
2#
3#
4#
5#
6#
9#
1
26~37 #
Factory default setting: 26
To set Wiegand format
To set keypad transmission
format
Note: When device reset to factory default, the
setting is still valid
0~2 #
3
2
17
18
1 #