Seat Arona 2018, Owner'S Manual

Page: 279 / 372

Driver assistance systems
until the system requests it. Doing so disa-
bles the system during the manoeuvre, re-
sulting in the parking being cancelled.
CAUTION
●
In certain circumstances, the ultrasonic
sensors do not detect objects such as trail-
er tongues, bars, fences, posts or thin trees,
or an open (or opening) rear lid, which
could damage the vehicle.
●
Retrofitting of certain accessories to the
vehicle, such as a bicycle rack, may inter-
fere with the operation of the Park Assist
system and cause damage.
●
The Park Assist system uses as a refer-
ence parked vehicles, curbs and other ob-
jects. Make sure that the tyres and wheels
are not damaged while parking. If necessa-
ry, opportunely interrupt the parking ma-
noeuvre to avoid damaging the vehicle.
●
The ultrasound sensors on the bumper
may be damaged or shifted in the event of
a collision, for example, when entering or
exiting a parking space.
●
If you use high-pressure or vapour equip-
ment to clean the ultrasound sensors, do
not apply it directly unless very briefly and
always from a distance of more than 10 cm.
●
A registration plate or plate holder on the
front with larger than the space for the reg-
istration plate, or a registration plate that is
curved or warped can cause:
–
false detections,
–
loss of sensor visibility.
–
cancellation of the parking manoeuvre
or defective parking.
●
If one of the ultrasonic sensors is dam-
aged, the area corresponding to that group
of sensors (front or rear) is deactivated and
cannot be activated until the fault is cor-
rected. However, you can still use the sen-
sors of the other bumper as per usual. If
there is a fault in the system, consult a spe-
cialist workshop. SEAT recommends visiting
a SEAT dealership for this.
Note
●
In order to guarantee good system oper-
ation, keep the ultrasound sensors of the
bumper clean, free of snow or ice, and do
not cover them with adhesives or other ob-
jects.
●
Certain sources of noise, such as rough
asphalt or paving stones and the noise of
other vehicles can induce the Park Assist
system or ParkPilot to give erroneous warn-
ings.
●
In order to become familiar with the sys-
tem and its functions, SEAT recommends
that you practice operating the Park Assist
system in an area where there is not too
much traffic or in a car park.
Description of the Park Assist sys-
tem
Fig. 248
In the centre console: button to
switch on the Park Assist system.
The components of the Park Assist system
are the ultrasonic sensors located in the front
and rear bumpers, the

button
›››
Fig. 248
to switch the system on and off and the mes-
sages on the instrument panel display.
Prematurely stopping or automatically in-
terrupting the manoeuvres for parking or
exiting a parking space
Park Assist interrupts the manoeuvres for
parking or exiting a parking space in any of
the following cases:
●
Press the

button.
●
The speed exceeds approximately 7 km/h
(4 mph).
●
The driver takes hold of the steering wheel.
»
277