Sealy Posturematic Adjustable Base Inspire, Owner'S Manual

Page: 13 / 20

13
SYNCHRONIZING TWO BEDS FOR
TANDEM OPERATION
STEP 1
Plug both Bed A and Bed B to working electrical outlets.
Using a surge protector is recommended.
STEP 2
Press the FLAT button on Remote A and Remote B to
align the beds properly in a flat position.
STEP 3
Unplug and then plug Bed B again to put it back into
pairing mode. Pairing mode lasts for seven (7) seconds.
STEP 4
Using Remote A, press the ZG and Foot Up (

) buttons
at the same time for three (3) seconds. The LED light
on the control box on Bed B lights up and remains on,
which means the pairing is successful.
Bed A and Bed B can now be controlled simultaneously
using Remote A.
RESET TING YOUR SYSTEM
STEP 1
Unplug the power cord from the electrical outlet.
STEP 2
Press and hold the FLAT button to continue sending a
signal to the control box then plug the power cord back in.
STEP 3
After seven (7) seconds, release the FLAT button.
STEP 4
Pair the remote control with its original control box.
Remote Control Guide
NOTE:
To operate two adjustable bases simultaneously,
you must pair both beds (Bed A and Bed B) to one
remote control (Remote A).
NOTE:
When operating beds in tandem, make sure both
beds are always plugged into working electrical
outlets.
NOTE:
Resetting the system is sometimes necessary to
restore the system to its factory setting, clear a
system error, or change a tandem system to a single
system or to two independent systems.
NOTE:
The control box must receive the FLAT signal from
the remote control for at least 5 seconds after
the power cord is plugged back in. The reset is
complete.