Sealy Posturematic Adjustable Base Inspire, Owner'S Manual

Page: 12 / 20

12
Remote Control Guide
REMOTE FEATURES
NOTE:
This bed may show minor intermittent performance
because of typical RF interference. This is normal in
the operation of the bed, not a defect.
• The buttons are backlit when pressed to aid in
the visibility of the remote control in low light
environments.
• It is not necessary to face the receiver when
operating the remote control. Remote signal is best
transmitted within 9 feet (3 meters) of the adjustable
base.
SAFET Y
• In the case that an overload of weight is placed on
the head or foot mechanism, the control unit will
automatically stop all functions. The control unit
will automatically resume all functions 30 seconds
after excess weight is removed.
• The input transformer voltage is AC240V 50HZ.
The output voltage is DC29V 3A. In the case of a
short circuit, a fuse on the transformer will blow to
protect the electrical equipment (Fuse: 1A~1.5A).
Should this occur, you MUST seek professional
assistance to replace the fuse. Call Sealy Customer
Care at 1300 130 221.
PAIRING YOUR REMOTE CONTROL
TO YOUR ADJUSTABLE BASE
w
STEP 1
Plug your adjustable base to a working electrical outlet.
Using a surge protector is recommended.
The control box automatically enters and stays in pairing
mode for seven (7) seconds.
STEP 2
On the remote control, press the ZG and Foot Up (

)
buttons at the same time for three (3) seconds.
The LED light on the control box lights up and remains
on, which means the pairing is successful.
Your remote control is now successfully paired with
your adjustable base.
NOTE:
The changes or modifications not expressly
approved by the party responsible for compliance
could void the user’s authority to operate the
equipment.
NOTE:
Your adjustable base is already paired to your remote
control at the factory. Manual pairing is only needed
for replacement remote controls or to change
tandem systems back to a single system.
NOTE:
For the pairing to be successful, make sure the
distance between the control box and the remote
control is not more than 2 metres.