Sealy Posturematic Adjustable Base Inspire, Owner'S Manual

Page: 10 / 20

10
STEP 9: INSTALL THE MATTRESS
RETAINER BRACKET
Align the open ends of the retainer bracket with the
"loop" retainer anchors located at the foot of the
adjustable base. Then, slide the retainer bracket into the
anchors allowing the ends to glide into the loop.
STEP 10: ASSEMBLE THE
HEADBOARD BRACKET (OPTIONAL)
Using the remote control, raise the head section of the
adjustable base to its full height. Locate the round panel
under the head section of the bed. The second round
panel is for the bed leg.
Position the inner headboard bracket underneath
the first round panel. The bracket opening should be
facedown under the bar. Insert the small screw fitted
with a washer into the slot under the inner headboard
bracket and through the round panel. Tighten the bolt
using the Allen key wrench.
Place the open side of the outer headboard bracket
onto the exposed square tube of the inner headboard
bracket. Insert the retainer bolt fitted with a washer
through the outer headboard bracket and into the inner
headboard bracket. Tighten the bolt using the Allen key
wrench. Leave loose enough for adjusting.
Repeat the steps to install the brackets on the other end
of the head section of the adjustable base.
When the headboard brackets are assembled, make sure
there is a space of 1.5 inches (38.1 mm) to 2 inches (50.8
mm) between the edge of the bed and the headboard
brackets.
Securely fasten the headboard bracket bolts (not
included with your adjustable base) to the end of the
headboard bracket assembly. If you need to adjust the
headboard brackets, unscrew the bolts holding the
outer headboard bracket and move them the necessary
distance. Screw the bolts back and tighten securely.
Installation Guide
NOTE:
If the adjustable base is setup without a headboard,
place your mattress on the bed surface. Installation
is now complete. For owners who purchased the
optional Headboard Bracket Kit, proceed to Step 10
to install the headboard bracket on your adjustable
base.
IMPORTANT!
FAILURE TO FOLLOW THE INSTALLATION STEPS AS
THEY APPEAR IN THIS GUIDE COULD RESULT IN
DAMAGE TO YOUR ADJUSTABLE BASE.
MAKE SURE TO POSITION THE BOTTOM OF THE
HEADBOARD CROSS MEMBER NO MORE THAN 3
INCHES (76.2 MM) BETWEEN THE HEADBOARD AND
THE TOP OF THE MATTRESS.