• 9 •
PROBlEM
sOlUTiOn
When cable is connected only
to the battery: Solid Red LED,
(Green LED off); beeps once
per second.
The vehicle battery voltage is lower than
10.5V. User can connect to the jump
starter and turn key to jump start the
vehicle.
When the cable is correctly
connected to both battery
and jump starter: Green LED
blinking: RED LED off; no beep.
“Fake” high battery voltage is detected
but reverse charging protection did not
activate. User can turn key to jump start
the vehicle.
smart Cable lED Behavior
Green LED lit solid
Ready to jump start
Green LED flashes three times Reverse charging protection
Red LED flashes once
Reverse polarity protection
Red LED flashes twice
Short circuit protection
Red LED flashes four times
Low voltage protection
Red LED flashes five times
High temperature protection
Red LED lit solid
OK to press button to jump start
12. sPECiFiCATiOns
Internal battery type .......................................... Lithium ion polymer
Capacity ............................................................8,000 mAh/29.6 Wh
USB output .............................................................5V DC, 2.1A / 1A
Jump start ................................................600A peak/300A cranking
Charging temperature ........................................................0°-50 °C
13. DisPOsAl inFORMATiOn
13.1 internal Battery
• The battery must be removed from the appliance before it is scrapped.
• The appliance must be disconnected from the supply mains before
removing the battery.
• The battery must be disposed of safely.
Under the Waste Batteries and Accumulators Regulations
2009, Jack Sealey Ltd are required to inform potential
purchasers of products containing batteries (as defined within
these regulations), that they are registered with Valpak’s
registered compliance scheme.
Jack Sealey Ltd’s Batteries Producer Registration Number
(BPRN) is BPRN00705
