• 6 •
7.2 ChARging ThE inTERnAl BATTERY
NoTe:
For best results, use a 2A micro USB-USB cable to charge.
NoTe:
Use a 2A USB charger (sold separately), or a 2A USB
charging port to quickly recharge the jump starter. Using a charger
with less than 2A will increase charge time.
1. Plug the Micro USB end of the charging cable into the input port.
Next, plug the USB end of the charging cable into a charger’s USB
port.
2. Plug your charger into a live AC power outlet.
O
3. The LCD display will light, the digit begins to flash and show “IN”,
indicating that charging has begun.
4. The jump starter will fully charge in 3-4 hours. When the unit is fully
charged, the display will show “100%”.
5. When the battery is fully charged, disconnect your charger from the
outlet, and then remove the charging cable from the charger and
the unit. Slide the ON/OFF switch to the OFF position, if you are not
using the unit immediately.
6. Charge the unit as soon as possible after use.
OPERATing
8. OPERATing insTRUCTiOns
8.1 JUMP sTARTing A VEhiClE EnginE
iMPORTAnT: Do not use the jump starter while charging its internal battery.
iMPORTAnT: Using the jump starter without a battery installed in the
vehicle will damage the vehicle’s electrical system.
nOTE: The internal battery must have a charge if at least 40% to
jump start a vehicle.
1. Turn the ignition OFF.
2. Lay the DC cables away from any fan blades, belts, pulleys and other
moving parts. Make sure all of the vehicle’s electrical devices are turned off.
3. For a negative-grounded vehicle, connect the POSITIVE (RED) clamp
from the jump starter to the POSITIVE (POS, P, +) ungrounded post
of the battery. Connect the NEGATIVE (BLACK) clamp to the vehicle
chassis or engine block away from the battery. Do not connect the
clamp to the carburetor, fuel lines or sheet-metal body parts. Connect
to a heavy gauge metal part of the frame or engine block.
4. For a positive-grounded vehicle, connect the NEGATIVE (BLACK)
clamp from the jump starter to the NEGATIVE (NEG, N, -) ungrounded
post of the battery. Connect the POSITIVE (RED) clamp to the vehicle
chassis or engine block away from the battery. Do not connect the
clamp to the carburetor, fuel lines or sheet-metal body parts. Connect to
a heavy gauge metal part of the frame or engine block.
5. Plug the battery clamp cable into the jump starter’s output socket.
6. Slide the ON/OFF switch to the ON position. Press and hold the
button on the smart cable for 1 second. The green LED should light.
nOTE: If the vehicle battery is extremely discharged, the initial current
draw from the jump starter may activate short circuit protection in the
