• 8 •
• Flash in strobe mode
4. When finished using the LED light, press and hold the display
button until the light turns off.
5. Slide the ON/OFF switch to the OFF position.
6. Recharge the unit as soon as possible after each use.
9. MAinTEnAnCE insTRUCTiOns
1. After use and before performing maintenance, unplug and disconnect
the unit.
2. Use a dry cloth to wipe all battery corrosion and other dirt or oil from
the battery clamps, cords, and the outer case.
3. Do not open the unit, as there are no user-serviceable parts.
10. sTORAgE insTRUCTiOns
1. Charge battery to full capacity before storage.
2. Store this unit at temperatures between -20°C – +60°C.
3. Never completely discharge the battery.
4. Charge after each use.
5. Charge at least once every month, if not in frequent use, to prevent
over-discharge.
11. TROUBlEshOOTing
PROBlEM
sOlUTiOn
The jump starter’s display will
not turn on.
Make sure the unit is charged.
Connect to a power source to reset.
Make sure the ON/OFF switch is set to
the ON position.
The thermometer symbol is
flashing
The unit is too hot or cold. The thermometer
symbol will disappear when the condition
is removed.
The jump starter will not
recharge.
Make sure the power source is live.
The jump starter turns on, but
won’t jump start my vehicle.
Check connections.
Verify the charge level of the jump starter is
at least 40%.
Do not attempt to jump start your vehicle
more than three consecutive times. If
the vehicle still does not start, consult a
qualified service technician.
