Section 3. Operation
SLCT-FAL5645 Sealing Machine
© Sealed Air Corporation (US)
MM-0110; Revision 1-A: 11/01/2013
3-5
3.3 INSTALLING THE SHRINK FILM
The dimensions of the packing product are width (W), the height (H), and the length (L) as
shown in Figure 3–33.
Figure 3–3 Packing Product Dimensions
1. Start the conveyor.
2. Check that the belt is tracking at the center of the bed. If not, follow the adjustment procedure
on Page 2-5 to adjust the belt.
3. Select the appropriate shrink fi lm:
Width of shrink fi lm = W (Product Width) + H (Product Height) + 5” ~ 7” (depends on the
height of the packing product).
4. Adjust the infeed conveyor Height (see Figure 3–4): Rotate the conveyor adjusting wheel to
adjust the height of the triangular plate. The correct position is about 1/2 H (Product Height)
+ 5~10mm.
5. Adjust of the infeed conveyor relative to the product guide (Figure 3-4)by placing a product
on the belt and then squeezing the handle on the front of conveyor unit. This will enable
movement of the conveyor unit to the appropriate width which is W (Product Width) plus
one-third of the product height.
