Section 2. General Information
SLCT-FAL5645 Sealing Machine
© Sealed Air Corporation (US)
MM-0110; Revision 1-A: 11/01/2013
2-8
Figure 2–6 Safety Actuator
If the jaw safety does not work properly: Loosen the top actuator screw and raise or lower it
to allow the sensor to detect the packing product quickly. The distance between the two touch
screws should not be too long, otherwise, the sealing blade will alarm and stop operation before
completing the sealing and cutting action.
2.3 REMOVING THE WASTE FILM (SELVAGE)
The fi lm trimmed from the side during the packing process is called selvage. Selvage is collected
on a wheel located in a compartment at the front of the machine. Refer to Figure 2-7 and follow
the next procedure to remove the waste fi lm that has accumulated on the selvage winder.
1. Open the door to access the selvage winder.
2. Loosen the wheel lock on the front of the wheel, and remove the guide plate.
3. Remove the waste fi lm,
4. Replace the guide plate and tighten the locking cap.
5. Run out some fi lm and re feed the selvage to the wheel. If the wheel slips during the
receiving process, tighten the locking nut a little bit to increase the friction of the selvage
receiving reel
Figure 2–7 Selvage Winder
Selvage Winder
Location
Wheel Lock
Guide Plate
Adjust Actuator
