Sealed Air Diversey Care TASKI swingo 2100 micro, Technical Manual

Page: 51 / 149

GTS Technical Manual
11. December 2015 Edition: V1.00/2015 5-28
Copyright © 2015, Diversey Care
05
.3
0.1
4 t
ool lower
ing un
it - li
ne
ar
drive offset - 21
00
µicr
o_V1.0
0.f
m
5.6 Tool lowering unit
5.6.3 Removing of linear drive for offset
Picture 36: Linear drive for offset
• Lower the brush drive for easier access.
• Remove the seat cover according to chapter REMOVING OF SEAT
COVER.
• Disconnect the linear drive (4127185) for the offset at the
electronics (4131532).
• Thread out the cable of the linear drive for the offset.
• Remove the one retaining washer (4058370) from the bolt
(4127022) of the linear drive for the offset.
• Thread out the bolt.
Picture 37: Removing linear drive for offset
• Remove the screw (4006050) of the flange bolt (4131412) which
fixates the linear drive of the offset to the holder (4131403).
Remarks
You need to remove the linear drive for the offset with the flange bolt
(4131412) mounted, as there is no room to lift the linear drive for the
offset over it.
The flange bolt (4131412) has a milled position where you can use a
10mm fork tool for fixation.