SEAL 62Pro, User Manual

Page: 46 / 228

44 User Manual 62Pro
Too much heat in the final result
Figure 28: Wrinkles due to too much heat.
The result is still too hot after the pull rollers. The bottom pull roller also gets hot.
•
Reduce the heater settings.
•
Check the function of the optional cooling device or have the device installed.
Roller alignment fault.
Figure 29: Wrinkles due to faulty roller alignment.
The wrinkles occur on one side only (left or right).
•
This is a machine adjustment error. Contact your dealer and ask for technical
assistance.
Material rolls are jumping.
A regular tick can be heard in the shaft suspension.
•
Adjust the shaft support (1) by turning up or down the screw (2) with an Allenkey (3).
Figure 30: Shaft support adjustment.
6.4 Technical assistance
For technical assistance you can contact your dealer or the address on the copyright page
in the front of this manual.
Make a clear description of the problem before contacting technical assistance.
Please keep the type and serial number of your machine at hand.
You can find this data on the identification plate of your machine, which can be found on
the rear side of the right cabinet.