SEAL 62Pro, User Manual

Page: 36 / 228

34 User Manual 62Pro
Now web the lower section
Figure 19: Webbing lower section.
4. Lift the in-feed table and put it in the upper position.
5. Unwind the film from the lower unwind roll.
•
Feed a pressure sensitive film without release liner underneath the splitter bar (A).
•
Feed all other films over the splitter bar (B).
6. Pull the film forward until the end reaches above the nip and stick it to the film from the
upper section.
If the film has a release liner:
•
Peel off the release liner.
•
Pull it underneath the wind-up shaft.
•
Stick it from below onto the cylinder on the wind-up shaft.
7. Lower the in-feed table.
When encapsulating:
•
Set the top pull roller in the upper position and lock it on both sides.
8. Push the films with a leader panel into the nip using slow mode.
Note:
Use a leader panel of the same material, thickness and width as the panels to process.
When encapsulating it is recommended to use the provided release board as a leader.
9. Stick the front end of the image to the leader panel, or butt up the next panel.
10. When the leader panel is through the nip, set the pressure for optimum result.
11. Refit the image guide
While feeding the images:
•
Check and adjust the tension on the unwind- and wind-up shafts.
•
Check and adjust the pressure setting.
•
Now speed can be set to normal.