Seagate Viper 200, Scsi Interface Manual

Page: 115 / 136

Page
106
LTO SCSI Interface Manual
Sense
Key
Byte 2
ASC
Byte 12 ASCQ
Byte 13
Message Explanation
06h 3Fh 01h Microcode has been
changed The firmware in the drive has just
been changed by a Write Buffer
command or firmware tape.
06h 3Fh 0Eh Reported LUNs Data Has
Changed Command Forwarding has been
changed from disabled to enabled
or vice-versa.
06h 3Fh 10h Media Loadable Medium has transistioned to a
loadable state.
06h 3Fh 11h Auxiliary Cartridge Mem-
ory accessible. Medium has transistioned to MAM
accessible state from a MAM inac-
cessible state.
06h 5Bh 01h Threshold condition met
06h 5Dh 00h Failure prediction thresh-
old exceeded
06h 5Dh FFh Failure prediction thresh-
old exceeded false A Mode Select command has been
used to test for Failure Prediction
system.
06h 67h 00h Power on reset or bus de-
vice soft reset occurred
07h Data Protect
07h 27h 00h Write protected A Write type operation has been
requested on a tape that has been
write protected.
07h 30h 00h Incompatible medium in-
stalled A Write type operation could not be
executed because it is not sup-
ported on the tape type that is
loaded
08h Blank Check
08h 00h 05h EOD detected A Read or a Space command ter-
minated early because End of Data
was encountered.
08h 14h 03h EOD not found A Read type operation failed be-
cause a format violation related to a
missing EOD data set
08h 30h 01h Cannot read medium un-
known format
08h 30h 02h Cannot read medium in-
compatible format
09h Vendor Unique
09h 00 05 VS EOD detected Raw reader
09h 80 80 VS Medium is present Park Unpark command
0Bh Aborted Command
0Bh 08h 01h LUN communication time
out
0Bh 1Bh 00h Synchronous data transfer
error
0Bh 3Dh 00h Invalid bits in identify
message An illegal Identify message has
been received by the drive at the
start of a command.
0Bh 43h 00h Message error A message could not be sent or re-
ceived due to excessive trans-
mission errors.