DOCS-001 Manual, SeaBotix Inc. Users, 150 – 200 Series - Rev B – 27 Jan 10 -
Page 39 of 64
Warning:
When placing the LBV on it’s side care and attention
must be paid to any cabling exiting the camera chassis. Placing
stress on these cables can damage the cable and or the water tight
integrity of the LBV itself.
Step 10
Remove the four M6 x 20 button head screws securing
the bumper frame to the shell.
TO005 Required.
Step 11
Fasteners removed:
1 ea Lead Trim Weight if installed.
2 ea M4 X 20 Button Head Screws
2 ea M4 X 25 Button Head Screws
Step 12
If a grabber is installed, disconnect the grabber at this
time. Now remove the bumper frame with the crossbar
still attached.
Step 13
Remove the M6 Nyloc nut securing the front of the shell
to the camera housing end cap.
TO012 Required.
Step 14
Remove the M4 x 50 Phillips head screw securing the
rear portion of the shell to the float.
Note the grey standoff located between the shell and the
float.
TO015 Required.
Step 15
Recover the grey standoff as you remove the M4 x 50
Screw.
