Sea Tel ST24, Operation And Installation Manual

Page: 55 / 101

ST24 Ku-Band TVRO Maintenance
6-11
Using snips carefully cut the tie wrap that secures
the (previously unused) IF coaxes to the GPS
Antenna Cable service loop.
Route the four coaxes up to and secure to LNB.
Using a tie wrap secure coaxes and Motor/Encoder
Harness to the LNB.
Using another tie wrap secure the coaxes to the
Motor/Encoder wire harness.
Ensure a large enough service loop to allow for full
range of motion in Polarization at all elevation look
angles.
Install the Motor Driver and Encoder IDC Connectors
on to the PCU PCB as shown to the right.