Sea Tel 5012-91, Installation Manual, Page: 32 / 138

5012-91 Installation Manual Installation
3-12
3.7.3.1. Ships AC Mains
Connect the power cord from the rear panel of the MXP to AC voltage power source (UPS power
recommended).
3.7.3.2. J1 Modem RX
Connect this RXIF Output to the satellite modem RX Input using an appropriate coaxial cable.
3.7.3.3. J2 Antenna RX
Connect this RXIF Input from the antenna to this port on the rear panel of the MXP using coaxial
cable provided
3.7.3.4. J3 A/B & J4 A/B - Ethernet 4 Port 10/100 switch
Ethernet connections to computer, satellite modem LAN devices as desired.
3.7.3.5. J5 SFP Fiber Interface
SFP Gigabit Ethernet connection.
3.7.3.6. J6 Mini-USB Computer M&C Connection
Mini-USB Antenna M&C connection, if desired.
3.7.3.7. J7 USB Host
Not connected - -Future development .
3.7.3.8. J8 Console
Antenna M&C Serial connections.
3.7.3.9. J9 A/B Serial
Computer RJ-45 Serial M&C connections. A is mapped to the Radio serial M&C port of the ICU and
B is mapped to the Pass through serial M&C port of the ICU.
3.7.3.10. J10C Modem
RJ-45 Serial M&C connection to Satellite Modem Console Port.
3.7.3.11. J10D OBM
RJ-45 Serial M&C connection to Out of Band Management equipment, if used.
3.7.3.12. J11 Gyro
Terminal Strip for SBS or Synchro Gyro Compass interface connections. Wiring is:
Pin 1 Synchro R1
Pin 2 Synchro R2
Pin 3 Synchro S1 / SBS A
Pin 4 Synchro S2 / SBS B
Pin 5 Synchro S3 / SBS C
Pin 6 SBS COM