Sea-doo RXP-X 260, Operator'S Manual

Page: 74 / 156

OPERATING INSTRUCTIONS
mBAR PSI
BOOST
1
2
3
FUNCTION SELECTED - PRESET 1
1. PRESET 1 message
2. VTS setting number
3. VTS position indicator at setting 1
(bow down)
6. Press the SET button to save PRE-
SET 1 and display PRESET 2.
7. Press the VTS UP/DOWN button to
change the PRESET 2 VTS position.
Gauge will display setting 1 through
9 in the digital screen above PRE-
SET 2.
8. Press the SET button to save the
settings and return to the main dis-
play.
The VTS system will compare the pre-
set trim settings recorded, the highest
position will be assigned to the UP but-
ton (bow up), the lowest to the DOWN
button (bow down).
If both trim positions are identical, both
buttons will have the same trim set-
tings.
Trimming the VTS Using the
Mode/Set Buttons
With the engine running in forward po-
sition, proceed as follows:
1. Press the MODE button to display
the VTS function in the multifunc-
tion display.
2. On the RH handlebar, press the
UP/DOWN button to change the
VTS setting.
mBAR PSI
BOOST
1
2
FUNCTION SELECTED - VTS
1. VTS message
2. VTS setting number
3. Confirm VTS operation by looking
for the VTS position indicator move-
ment in the digital display.
4. Press the SET button to save the de-
sired setting and return to the main
display.
NOTE: The available VTS settings are
between 1 and 5.
NOTE: The VTS system cannot be
fully tested without the engine operat-
ing in forward position. If the engine
is not running in forward position, only
the VTS indication will change when
the VTS control switches are pressed;
the nozzle will not change position.
General Operation
Recommendations
Rough Water or Poor Visibility
Operation
Avoid operation in these conditions. If
you must do so, proceed with caution
using minimum speed.
Crossing Waves
The operator must grip the handlebar
firmly and keep both feet on the foot-
boards.
The passenger must grip the hand-
holds with both hands and keep both
feet on the footboards.
Reduce speed.
72
______________