Sea-doo RXP-X 260, Operator'S Manual

Page: 73 / 156

OPERATING INSTRUCTIONS
smo2012-003-008_a
DOUBLE-CLICK UP OR DOWN VTS BUTTON
TO USE PRESET POSITIONS
1. Highest preset position on UP
2. Lowest preset position on DOWN
Recording Preset Trim Positions
Two different VTS trim positions may
be recorded for quickly selecting the
preferred watercraft trim attitude.
Both VTS PRESET trim positions are
factory set to 3 but may be changed
as per operator preference. When
the VTS PRESET trim positions are
changed by an operator, the new set-
tings will remain recorded in memory
even after complete watercraft power
down.
To record VTS preset trim positions:
1. Turn ON the electrical power by
pressing the START/STOP button
once.
2. Install the tether cord on the engine
cut-off switch.
3. On the RH handlebar, press the
MODE button repeatedly until VTS
MODE is displayed.
smo2012-003-007_a
1. MODE button
2. SET button
3. UP/DOWN button
mBAR PSI
BOOST
MESSAGE DISPLAYED
VTS MODE
4. On the RH handlebar, press the SET
button to display PRESET 1.
5. Press the VTS UP/DOWN button to
change the PRESET 1 VTS position.
Gauge will display setting 1 through
9 in the digital screen above PRE-
SET 1.
_______________
71