Sea-doo 210 Challenger Series, Operator'S Manual

Page: 57 / 156

GAUGES
Move switch stem up or down until the
preferred indication selection is visible
in the multifunction display.
Press the SET button to select and
save the preferred indication, or wait
for the display function to time out.
The last indication visible will be auto-
matically save. The numerical display
will then switch to the new indication
with a small abbreviation of the indica-
tion type to its right:
– FT or M
– RPM
– MPH or Km/h
– °F or °C.
– Lap
– Gal/h or L/h
– Min
– AM or PM.
For example, to display the ALTITUDE
information:
– Press the MODE button repeatedly
until DISPLAY is displayed,
– Then press SET button once
– Lift up the UP and DOWN switch un-
til ALTITUDE is displayed,
– And finally, press SET button to con-
firm and save your selection.
Lap Time Mode
Use the LAP TIME mode to compile
your times and thus improve your re-
sults. Up to 50 individual lap times can
be recorded.
The Lap Time mode is a chronograph
to compile intermediate times during a
course. You can see any individual lap
times or the total of lap times.
To activate and use the lap timer:
1. Press MODE button repeatedly un-
til LAP TIME is displayed.
n i
M A
h /l a g M P R
p a l
lmo2010-003-091
LAP TIME
2. Press the SET button once to con-
firm your selection. The first lap
timer will be displayed.
n i
M A
h /l a g M P R
p a l
lmo2010-003-092
FIRST LAP TIMER
3. When ready, press the SET button
to start the lap timer.
n i
M A
h /l a g M P R
p a l
lmo2010-003-093
LAP TIMER STARTED
NOTE: The timer starts immediately
when pressing the SET button.
4. To record each lap time, press the
SET button at the start of each lap.
_______________
55