SCS P4dragon DR-7800, Installation Manual

Page: 66 / 96

5. Installation
Figure 6: Installing the standoffs
The bottom side of the Bluetooth transceiver has a connector which mates with the connector
on the
P4
dragon mainboard.
Figure 7: The Bluetooth module
Align the Bluetooth transceiver on the standoffs so that the mating connectors are close
together and matching. Then press down the Bluetooth transceiver so that it rests in the
standoffs while the connectors slip in each others. It is recommended to press the small forks
on the top of the standoffs a bit towards each others using a calliper to reduce the necessary
insertion force. But it will still need some force to press the module down, although it must be
done very carefully. This picture shows the Bluetooth transceiver when being installed:
Figure 8: The Bluetooth module installed
61