SCS LABCOTER 2, Operator'S Manual

Page: 62 / 153

Rev 37 Operator’s Manual OM-610-1002-1
page 54 SECTION 6 MAINTENANCE PDS-2010
Scale Range Lower Limit. The default value is 1000 for linear input or a range maximum for temperature
inputs.
SP - Setpoint
This is a controller parameter; it is the target value at which the controller will attempt to maintain the
process variable by making adjustments to the power output level.
SPLL - Set Point Low Limit
This is the minimum limit for set point adjustment. It should be set to a value that avoids causing damage
to the process being controlled. The Set Point Low Limit may be adjusted between the Input Range
Minimum and the current set point value.
SPr - Set Point Ramp
This parameter enables/disables use of the set point ramping feature at user level (diSA = Disabled, EnAb
= Enabled).
SPuL - Set Point High Limit
This is the maximum limit for set point adjustment. It should be set to a value that prevents the set point
being given a value that will cause damage to the process being controlled. The Set Point High Limit may
be adjusted between the current set point value and the input Range Maximum.
Note: For more information see the Manufacturer’s Literature.