Scott Safety Protege ZM, System Manual

Page: 91 / 116

Troubleshooting
71
SCOTT SAFETY 087-0048 REV B
Test Station
Hardware
(Continued) Run time below
requirements or
battery damaged
•
Verify connection.
•
Replace Lithium Rechargeable Battery, item #6 in
Figure 50 .
Bump or Calibration
Push Button loss of
function or shows
physical damage
•
Verify connection and function.
•
Replace applicable Push Button Switch, item #35 in
Figure 51 , and in Figure 52 .
USB Cover Bracket
shows physical
damage or
misplaced
•
Replace USB Cover Bracket, item #26 in
Figure 51 ,
and Figure 52 .
USB Shroud Block
shows physical
damage
•
Replace USB Shroud Block, item #27 in
Figure 51
and Figure 52 .
Lithium Battery
Holder shows
physical damage
•
Replace Lithium Battery Holder, item #7 in
Figure 50 .
IR PCB Shroud
Block shows
physical damage
•
Replace IR PCB Shroud Block, item #28 in
Figure 51 and Figure 52 .
Gas leak
•
Replace Teflon tape.
•
Replace 1/8” High Pressure Tube Fitting, item #33 in
Figure 51 .
Tygon tubing does
not stay in place or
excess leaking
•
Replace Bulkhead Fitting 5/16” Tube, item #32 in
Figure 51 , and Figure 52 .
Improper readings or
gauge leaks
•
Replace Gauge, item #36 in
Figure 51 .
Calibration Cap
damaged
•
Replace Calibration Cap Modification, item #2 in
Figure 50 .
Calibration Cup
Holder Bracket
damaged
•
Replace Calibration Cup Holder Bracket, item #3 in
Figure 50 .
Calibration Bottle
Mount damaged
•
Replace Calibration Bottle Mount Kit, item #29 in
Figure 51 .
Table 24 Troubleshooting Matrix (continued)
ITEM SYMPTOM/CAUSE SOLUTION