16
Water supply install
Fit 15mm to 1/4 inch adapter to stop
tap. Tighten until hand tight then give
it a light nip up with spanner.
NOTE: Do not over tighten
Fit 1/4 inch blue water supply tube to
adapter on stop tap
Press fully into connector.
Fit PRV with arrow pointing way of flow, con-
nect blue tube coming from supply to the inlet
of the Valve and connect a length of tube to
the outlet. Fasten clip to wall using one screw,
and clip PRV into place.
Fit bracket to filter head using 4 screws
take note of the
IN
and
OUT
on the
head, attach bracket the appropriate
way around depending on which side
of the chiller the filter is placed on.
1
2
3
4
Summary of Contents for SC80
