Assembly
24
01.00|KSP3-IM, KSP3-LH-IM |en
Mounting with cylindrical pins (Z variant):
The clamping force block is fastened to the machine table with 4
screws (item 84). The two cylindrical pins (item 34) are used for
alignment with repeat accuracy. Do not realign the clamping force
block after removing it from the machine table (e.g. after replacing
the seals).
Mounting the clamping force block on the base plate
(if the two parts are delivered separately)
When mounting TANDEM clamping force blocks on TANDEM base
plates
ABP-h, ABP-a
or
SBP
, use the shorter mounting screws
included in the base plate accessory kit instead of the standard
mounting screws (item 19) that come with the clamping force
block.
For
KSP3 100-IM, KSP3-LH 100-IM:
Use the
M8 x 30
screws from the base plate accessory kit instead
of the M8 x 35 screws (item 84).
For
KSP3 160-IM, KSP3-LH 160-IM:
Use the
M10 x 35
screws from the base plate accessory kit instead
of the M10 x 40 screws (item 84).
For
KSP3 250-IM, KSP3-LH 250-IM:
Use the
M12 x 40
screws from the base plate accessory kit instead
of the M12 x 45 screws (item 84).
NOTE
If the clamping force block and base plate are ordered separately,
the screws, O-rings and clamping sleeves for assembling the parts
are included in the accessory kit that comes with the clamping
force block.
• Do not open the connections on the front of the clamping force
block (
I, II
), or seal them with suitable dummy plugs (M5 or
G1/8").
• Insert the clamping sleeves from the accessory kit into the
centering holes on the base plate.
• Remove the center plugs from the base plate (internal air feed-
through
III, IV
) and insert the O-rings from the accessory kit
into the recesses for the air feed-throughs.
• Mount the clamping force block onto the base plate.
5.2
