Maintenance and care
26
03.00|KSF plus, KSF-LH plus, KSF-F plus |en
diagonal sequence. It is absolutely necessary to install the
original fastening screws (item 21) afterwards.
27 If using clamping sleeves (item 27) for centering, insert these
into the housing (item 1) now.
28 Grease the sliding surfaces of the housing (item 1), base jaws
(item 2) and chuck piston (item 3) with LINOMAX 200 or an
equivalent lubricant.
29 Assemble the base jaws (item 2) and the chuck piston (item 3).
Be sure to observe the installation position for the base jaws
and the chuck piston.
Additionally for the KSP-F plus variant:
–
Mount the base jaw (item 31) into the housing (item 1).
–
Mount the positioning bolt (item 29) between base jaw
(item 31) and housing (item 1).
–
Screw in the screw (item 32) between the base jaw (item
31) and the housing (item 1).
30 Connect the clamping block to the air supply and set the jaws in
the OPEN position.
31 Screw down the chuck piston (item 3) and cylinder piston (item
4). Tighten the screw (item 14) with a torque wrench
32 Fasten the guide strips (item 6) and the covering strip (item 7).
33 Check for leaks.
