Maintenance and care
03.00|KSF plus, KSF-LH plus, KSF-F plus |en
25
removed after being heated by a hot-air blower. The sleeve
should therefore remain built into the base body.
13 Remove the seals (items 20, 22).
14 Remove the seals (items 12, 15, 17).
15 Clean all the parts thoroughly and check for damage and wear.
Damaged and worn parts must be replaced.
16 Lubricate the new seals (items 12, 15, 17, 20, 22) with Renolit
HLT 2 or equivalent grease.
17 Mount the new seals carefully. The seals must not be damaged
in the process.
18 Place the O-Rings (items 20 and 22) in the housing (item 1) and
lay the O-ring (item 17) around the cover (item 5).
19 Grease the sliding surfaces of the cylinder and piston with
Renolit HLT 2 or equivalent grease.
20
For model size 100
: insert the sleeve (item 42) with the collar in
front into the housing.
For model sizes 140, 160 and 250:
place the sleeve (item 42)
with the conical taper facing forward into the housing and
screw it to the body (item 1) by fastening the screws (item 43).
21 Grease the springs of the disassembled spring assembly with
Renolit HLT 2 or an equivalent grease. Assemble the spring
assembly; the spring coils have an alternating clockwise and
counter-clockwise thread.
22 Loosely insert the cylinder piston (item 4) into the cylinder,
ensuring that the spring assembly is positioned centrally and
not displaced. Lay the end coils of the innermost springs into
the recess in the cylinder piston.
23 Gently press the quad ring (item 12) inwards from all sides so
that it slides more easily over the edge of the cover (item 5).
24 Carefully push the cover (item 5) over the cylinder piston (item
4) as well as the sleeve, making sure that the openings of the
air feed-throughs lie vertically opposite each other.
25 Carefully clamp the clamping block into a suitable assembly
device between the housing (item 1) and the cover (item 5).
Work carefully while assembling the parts and make sure that
the cover is not twisted in the housing.
26 Insert the screws (item 21) and screw the cover (item 21) onto
the housing (item 1). Observe the screw-tightening torques
Alternatively, the cover can also be assembled with mounting
screws in graduated lengths by tightening them in cross-wise
