Maintenance
25.00 | DPZ-plus | Assembly and Operating Manual | en | 389035
43
Assembling
Ø
Push the base jaw (2/7) into the housing (1), observing the
correct installation position.
Ø
Insert the piston (3/8) into the housing (1) from above.
Ø
Position the base jaws (2/7) so that the piston (3/8) can be
pushed into the base jaws (2/7) without any problems.
NOTE
Do not damage the sealing lips of the seal (30) while pushing in
the cylinder piston.
Ø
Insert the cylinder piston (60) from below into the housing (1),
observing the correct installation position.
Ø
Screw in the screw (40).
Ø
Fasten the cover (4) with screws (41).
NOTE
The product must be in the "closed" position to prevent the
gasket (14) from being clamped in the housing (1) by the
intermediate jaw (13).
Ø
Insert the gasket (14) in the housing (1).
NOTE
Do not damage the sealing lips of the seal (36) with the
intermediate jaw (13).
Ø
Put on the side cover (12), making sure the installation position
is correct.
Ø
Do not screw the screw (42) completely into the cover (12). The
gap between the side cover (12) and the housing (1) should be
approximately divided in half.
Ø
Allow the gripper to run for about 20 cycles so that the side
covers (12) can be centered with respect to the base jaws (2/7)/
intermediate jaws (13), the gasket (14) and the housing (1).
Ø
Tighten the screws (42) to fasten the side cover (12).
Ø
Apply a strip of Plast-o-Seal along the side cover (12),
the Plast-o-Seal (previous version)
53].
Ø
Insert the seal (37) into the housing (1).
Ø
Screw the cover plate (5) on tight with the screws (47).
Ø
If necessary, install the pressure piece, see insert "Installation
instructions - pressure piece".
