Maintenance
25.00 | DPZ-plus | Assembly and Operating Manual | en | 389035
61
Assembling
NOTE
Tighten all screws with the required tightening torque.,
64].
Ø
Push the base jaw (2/7) into the housing (1), observing the
correct installation position.
Ø
Position the base jaws (2/7) so that the piston (3/8) can be
pushed into the base jaws (2/7) without any problems.
Ø
Insert the piston (3/8) into the housing (1) from above.
NOTE
Do not damage the sealing lips of the seal (30) while pushing in
the cylinder piston.
Ø
Insert the cylinder piston (61) from below into the housing (1),
observing the correct installation position.
Ø
Screw in and tighten the screw (40).
Ø
Push the compression spring (25) onto the cylinder piston (61)
over the collar.
Ø
Insert the cylindrical pins (55) into the housing (1).
Ø
Insert seal (32) / O-rings (32/34) into the cover (9).
Ø
Fasten the cover (9) with the screws (46).
Ø
Insert the flat seal ring (39) into the side cover (12).
NOTE
Do not damage the sealing lips of the seal (36) with the
intermediate jaw (13).
Ø
Put on the side cover (12), making sure the installation position
is correct.
Ø
Do not screw the screw (42) completely into the cover (12). The
gap between the side cover (12) and the housing (1) should be
approximately divided in half.
Ø
Allow the product to run for about 20 cycles so that the side
covers (12) can be centered with respect to the base jaws (2/7)/
intermediate jaws (13).
Ø
Tighten the screws (42) to fasten the side cover (12).
Ø
Insert the flat seal (20) into the housing (1).
Ø
Screw the cover plate (5) on tight with the screws (47).
Ø
If necessary, install the pressure piece, see insert "Installation
instructions - pressure piece".
