SCHUNK DPZ-plus 100, Assembly And Operating Manual

Page: 22 / 76

Assembly
22
25.00 | DPZ-plus | Assembly and Operating Manual | en | 389035
Ø
Screw the product to the machine/system,
Mechanical connection [
}
23].
✓
When mounting from the rear: use cylindrical pins for fixing
the product in place.
✓
If necessary, use appropriate connection elements (adapter
plates).
✓
Observe requirements for adapter plate,
Mechanical connection [
}
23].
✓
Observe the maximal tightening torque, admissible screw-in
depth and, if necessary, strength class.
Ø
If necesssary, mount the pressure piece for spring-supported
positioning of the work piece against a stop,
Mounting of the
gripper by using a spring loaded pressure-piece [ } 24].
Ø
Secure the gripper fingers to the base jaws,
Mechanical connection [ } 23].
✓
Insert two centering sleeves per base jaw, positioned
horizontally or vertically opposite and fasten with four
screws.
✓
Observe the permissible depth of engagement.
Installing the ventilation connection or air purge connection
Ø
Dismantle the sinter filter (1).
Ø
Install the ventilation connection (2) or air purge connection (2),
Installing the ventilation connection/air purge connection [ } 26].
Ø
Connect the sensor, see assembly and operating manual of the
sensor.
Ø
Mount the sensor, Installing the sensors [
}
29].