Maintenance
25.00 | DPZ-plus | Assembly and Operating Manual | en | 389035
53
Ø
Push the intermediate housing (65) over the cylinder piston (6).
Ø
Fasten the cover (4) with screws (41).
NOTE
The product must be in the "closed" position to prevent the
gasket (14) from being clamped in the housing (1) by the
intermediate jaw (13).
Ø
Insert the gasket (14) in the housing (1).
NOTE
Do not damage the sealing lips of the seal (36) with the
intermediate jaw (13).
Ø
Put on the side cover (12), making sure the installation position
is correct.
Ø
Do not screw the screw (42) completely into the cover (12). The
gap between the side cover (12) and the housing (1) should be
approximately divided in half.
Ø
Allow the gripper to run for about 20 cycles so that the side
covers (12) can be centered with respect to the base jaws (2/7)/
intermediate jaws (13), the gasket (14) and the housing (1).
Ø
Tighten the screws (42) to fasten the side cover (12).
Ø
Apply a strip of Plast-o-Seal along the side cover (12),
Position of the Plast-o-Seal (previous version)
53].
Ø
Insert the seal (37) into the housing (1).
Ø
Screw the cover plate (5) on tight with the screws (47).
7.5.5 Position of the Plast-o-Seal (previous version)
Position of the item numbers,
Position of the Plast-o-Seal
