Schleuniger EcoCut 3300, Reference Manual

Page: 82 / 108

14. Appendix
82|108
Reference Manual |Edition 4.0 (10-2013) |EcoCut 3300
14.3
PRE-/POSTFEED INTERFACE (PPI, OPTION)
On the postfeed connector a Schleuniger CableCoiler or WireStacker or a customer specific device may be
hooked up, see chapter "14.3.1.1 POSTFEED connector (Page 82)" .
NOTICE
Caution, property damage!
Basically the interface is protected against overload, short circuit, electrostatic
discharge and electromagnetic interference. With inappropriate use, overload
situations may occur which are not covered by the internal protection circuitry.
This can lead to malfunction or even damage to the EcoCut 3300 .
14.3.1
POSTFEED interface
POSTFEED connector
RENCA
D-Sub 25-pin (F)
RENCA
+24 V
RDETECT
RIN0
RIN1/WSCONVEYORREADY
RIN2/CCSTART/WSBATCHREADY
RIN3/CCREADY/WSEJECTREADY
+24 V
RENCB
ROUT2/CCBINDING/WSBATCH
Gnd
Gnd
ROUT0
ROUT1/CCSTOP/WSCONVEYOR
ROUT3/CCEJECT/WSEJECT
Gnd
RENCB
Shield
POSTFEED
WSEJECT passive
Fig. 10: Pin assignment „POSTFEED“
Pin Description Function Signal type
1 + 24 V - Supply -
2 /WSEJECT passive Output for the ejection control of passive Wire-
Stackers
Output NPN
3 - (not implemented) - -
4 RDETECT Wire sensing Input NPN
5 RIN0 Multifunction input Input PNP