Check door dimensions.
See
consumer.schlage.com/Service-Support
for door
preparation instructions if dimensions are different.
Backset
2
C\,
” OR 2
C\v
”
(60 mm OR 70 mm)
5
Z\x
” OR 4”
(140 mm OR 102 mm)
Door Thickness
1
C\,
” to 1
C\v
”
(35 mm to 44 mm)
Crossbore
Diameter
2
Z\,
” (53 mm)
1” (25 mm) Hole
L
The firecup cannot be installed on a 1
C\,
” (35 mm) thick
door, and the lock will not retain the UL rating.
Install the lock
1
Install bolt and strike.
CAUTION
Use provided bolt!
1a Adjust bolt length, if necessary.
Backset
Measure the backset. If the
measurement is 2
C\,
” (60 mm) no
adjustment is necessary.
If the measurement is 2
C\v
” (70 mm), extend the bolt.
Twist the faceplate.
Make sure the button
pops into place.
1b If desired, change to the square-corner faceplate.
Use a flathead screwdriver
to pry the faceplate off.
Press the square-corner
faceplate into place.
1c
Install the firecup into the lower hole.
L
DO NOT install the firecup on a 1
C\,
” thick door.
Fire cup not
required for
deadbolt hole
Opening should
face the outside
of the door.
1d Install the bolt and latch into the door.
CAUTION
If the bolt does not remain retracted throughout installation, locking and
unlocking could be reversed, resulting in an unsecured residence.
Make sure the word
TOP
faces up when
installing the bolt.
Make sure
latch bevel
faces strike
plate.
Actual
Size (4)
1e Install the strikes.
Drill pilot holes
Z\,
” x 3” deep, 2 places.
Optional
OR
Reinforcement strike
Strike and
reinforcement plate
Actual Size
