16
XRZ PRO RS
CONTROLS
FOOT PEDAL LIFT LEVER (F)
-
Used to raise
the cutterdeck for curb climbing, blade changing and lift-
ing the deck close to the transport position. To return to
preset height of cut, lower foot pedal until latch lever
E
contacts height of cut pin
A
.
TRANSPORT LATCH LEVER (T)
-
Used to se-
cure the cutterdeck in transport position. To secure the
deck, push the foot pedal F forward aand lift the trans-
port latch lever T into the locking position. To release
transport latch lever
T
, push the foot pedal
F
slightly
forward to disengage latch and press transport latch
lever
T
downward. Allow foot pedal
F
to rotate toward
machine until latch lever
E
contacts height of cut pin
A
.
HEIGHT OF CUT PIN (A)
-
Sets height of cut and
allows easy return from transport to desired height of
cut. Raise the deck to transport using the foot pedal
and transfer latch lever
T
. Position pin
A
in the hole
corresponding to the desired height of cut. Lower the
latch lever until it rests on pin
A
.
12 VOLT POWER OUTLET (X)
-
A 12 volt
power outlet is provided to operate 12 volt personal
accessories.
FUEL SELECTOR VALVE (U)
The fuel tank selector valve is located behind the seat.
The fuel tank selector valve has three positions:
Off
: The tank selector is off when the lever points
down. The selector should be off whenever the ma-
chine is transported or stands unused for any length of
time. Shutting off the fuel supply avoids the possibility
of flooding should any dirt get under the carburetor float
needle. Leaving the tank selector in either tank position
can allow severe flooding, which may ruin the engine by
diluting the oil.
Right Tank
: Fuel flows from the right tank when the
selector is turned 1/4 turn toward the right
.
Left Tank
: Fuel flows from the left tank when the selec
-
tor is turned 1/4 turn toward the left.
